Inter-Tel AXXESS - Page 817

Page 5-291
System Features
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Trunk Groups
FEATURES
5
3. The display shows ENTER DATABASE OPTION. (Executive Display, Professional
Display, and Model 8560 Phones also show the options: STATION, SYSTEM, and
TRUNK.) Press or the
TRUNK menu button. The display shows ENTER TRUNK
OPTION.
4. Program an Individual Trunk: Press or the INDIVIDUAL TRUNK menu button.
Then program trunk options as follows:
a. The display shows ENTER TRUNK EXTENSION. Enter the extension number of
the trunk to be programmed using one of the methods described in paragraph
52.36.
b. The display shows INDIVIDUAL TRUNK OPTION. Enter one of the following
options. To view the last two options on an Executive Display, Professional Dis-
play, or Model 8560 Phone, press the arrow (<< or >>) menu button at the bottom
of the display.
Answer Supervision: To program the answer supervision for the trunk, press
or the
ANS SUPERVISION menu button. When the display shows ANS SUPER-
VISION OPTION, press or the
POLARITY REVERSE menu button for the
polarity-reversal supervision type. Or, press or the
VALID CALL menu button
for Valid Call timer supervision. Or, press or the
VALID + POLARITY menu
button for Valid Call timer with Polarity Reversal supervision. Then press or
ACCEPT to continue.
Caller ID [CLIP]: To enable or disable Caller ID [CLIP], press or the
CALLER ID menu button. When the display shows SET CALLER ID, press or
ON to enable the feature, or press or OFF to disable it. Then press or
ACCEPT to continue.
Hybrid Balance: To set the hybrid balance of the trunk to normal or short, press
or the
HYBRID BALANCE menu button. When the display shows HYBRID
BALANCE OPTION, press or the
NORMAL menu button, or press or the
SHORT menu button. Then press or ACCEPT to continue.
DTMF/Dial-Pulse Signaling: To set the trunk for DTMF or dial-pulse signaling,
press or the
SIGNALING menu button. When the display shows ENTER SIG-
NALING OPTION, press or the
DTMF menu button, or press or the
PULSE menu button. Then press or ACCEPT to continue.
Trunk Group Number: To assign the trunk to a trunk group, press or the
TRUNK GROUP menu button. When the display shows ENTER TRUNK GRP
EXTENSION, enter the desired trunk group number using one of the methods
described in paragraph 52.36.
Busy Trunk: To temporarily remove the trunk from service, press or the
BUSY
TRUNK menu button. When the display shows MARK TRUNK BUSY, press
or the
ON menu button, or press or the OFF menu button. Then press or
ACCEPT to continue.
a. To exit, press or ACCEPT to move backward through the prompts until you
reach the ENTER DATABASE OPTION prompt.
3
1
1
1
2
3
#
2
1
2
#
3
1
2
#
4
1
2
#
5
6
1
2
#
#