Page 5-299
System Features
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Working with the Modem
FEATURES
5
52.43 To erase system speed-dial names or numbers:
1. While on hook, enter the Program System Speed-Dial feature code (9801). Display
phones show PROGRAM SYS SPD # (000-999 or 0000-4999).
2. Enter the speed-dial location code (000-999 or 0000-4999). The display shows ENTER
NAME: (current name).
3. You may erase the name and/or number:
To erase the name: Press the button repeatedly until the name is erased or
press
CLEAR.
To erase the number: Press or
ACCEPT to display the ENTER NUMBER prompt,
then press the button repeatedly until the number is erased or press
CLEAR.
4. Press or ACCEPT to exit. You hear a single progress tone when accepted. Your dis-
play shows SYS SPD BIN #XXX UPDATED.
H. WORKING WITH THE MODEM
52.44 The Call Processing Card (CPC) has a built-in modem. This modem allows remote
users to access DB Programming. It also functions as a serial port, used for SMDR, Message
Print, etc. If necessary, System Administrators can enable, disable, or reset the modem and pro-
gram a DSS/BLF button to reflect the modem status. (For information about connecting to the
modem for DB Programming, see page 2-100.)
Enabling/Disabling the Modem
52.45 To enable/disable a modem:
1. Enter the Modem Enable (9866) or Modem Disable (9867) feature code. The display
shows ENABLE (DISABLE) MODEM EXT #.
2. Enter the extension of the modem (local or off-node) to enable/disable. The display
shows MODEM ENABLED (DISABLED).
52.46 If disabled, the modem is placed into DND. In the disabled state, the modem rejects all
calls and does not allow camp ons.
NOTE: If an invalid modem extension is entered, the display shows INVALID MODEM
EXTENSION.
To Next Page
Loading...
