Cisco ONS 15454 Series - Page 25

TABLES
xxv
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Table 1 Cisco ONS 15454 Procedure Guide Chapters xlvii
Table 1-1 Pin Assignments for the AEP 1-15
Table 1-2 Alarm Input Pin Assignments 1-17
Table 1-3 Alarm Output Pin Assignments 1-18
Table 1-4 Standoffs Required for EIA Types 1-23
Table 1-5 Shelf Installation Task Summary 1-30
Table 2-1 Card and Slot Compatibility for the XCVT Card 2-3
Table 2-2 Card and Slot Compatibility for the XC10G Card 2-5
Table 2-3 OC-N Card Transmit and Receive Levels 2-15
Table 3-1 CTC Computer Setup for Local Craft Connections to the ONS 15454 3-3
Table 4-1 Protection Types 4-10
Table 6-1 ONS 15454 Circuit Options 6-3
Table 6-2 CTC Circuit Source and Destination Options for VT Circuits 6-3
Table 6-3 CTC Circuit Source and Destination Options for STS Circuits 6-4
Table 11-1 Cisco ONS 15454 Card State Transitions 11-6
Table 15-1 Audit Trail Column Definitions 15-10
Table 15-2 ONS 15454 Timing Report 15-19
Table 15-3 Incompatibility Alarms 15-23
Table 17-1 External Timing Pin Assignments for BITS 17-25
Table 17-2 LAN Pin Assignments 17-26
Table 17-3 Craft Interface Pin Assignments 17-27
Table 17-4 Pin Assignments for AMP Champ Connectors 17-30
Table 17-5 Pin Assignments for AMP Champ Connectors (Shielded DS1 Cable) 17-31
Table 18-1 OC-N Cards that Terminate the Line, Called LTEs 18-7
Table 18-2 Managing Domains 18-20
Table 18-3 Line Options for DS1-14 and DS1N-14 Cards 18-29
Table 18-4 Line Thresholds Options for DS1-14 and DS1N-14 Cards 18-30
Table 18-5 Electrical Path Threshold Options for DS1-14 and DS1N-14 Cards 18-31
Table 18-6 SONET Threshold Options for DS1-14 and DS1N-14 Cards 18-31
Table 18-7 Line Options for DS3-12 or DS3N-12 Cards 18-33
Table 18-8 Line Threshold Options for DS3-12 or DS3N-12 Cards 18-34