Cisco ONS 15454 Series - Page 830

Index
IN-2
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
AINS Soak
DS1-14 card
18-30
DS3/EC1-48 card 20-83
DS3-12 card 18-34
DS3-12E card 18-38
DS3i-N-12 card 22-23
DS3XM-12 card 20-75
DS3XM-6 card 18-43
EC1-12 card 18-47
OC-N cards 18-51
AIP, replace 15-26
air filter
external brackets
1-2
install 17-4
install external brackets 17-4
location 1-11
requirement 1-10
AIS threshold 17-77
alarm expansion panel see AEP
alarm filtering
disable
19-17
enable 19-17
modify 22-16
alarm indication signal see AIS
alarm profiles
create
22-9
apply to ports 22-12
assign to cards and nodes 18-5
delete 22-14
download 22-20
alarms
environmental alarms see AIC card or AIC-I card
filtering see alarm filtering
severity profiles see alarm profiles
troubleshoot see Cisco ONS 15454 Troubleshooting
Guide
alarm expansion panel
1-12
check network for alarms 19-63
delete cleared alarms from display 7-3
disable alarm filtering 19-17
Ethernet RMON alarm thresholds 22-26, 22-28
history 18-1
raise (unsuppress) 22-19
suppress alarm reporting 22-17
synchronize 18-3
view 7-2, 20-85
view alarm counts on LCD 7-6
view history 22-8
alarm severities see alarm profiles
alarm wires
17-22
ALS mode 18-51
AMI 17-77
AMP Champ EIA
attach DS-1 AMP Champ cables
17-29
install AMP Champ EIA 17-16
pin assignments 17-30
area range table (OSPF) 19-35
ARP sniffing see automatic host detection
audit trail
off-load records
15-11
view records 15-9
automatic host detection 17-61
AWG
# 10
1-3
#22 and #24, solid tinned 1-3
#29, double-shielded 1-3
#6 stranded 1-3
B
B8ZS 17-77
backplane
interface connections see backplane connections
pins see backplane connections
see also secure mode
assign IP address to backplane LAN port
21-11
covers 1-7
remove lower cover 17-10