Index
IN-3
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
remove sheet metal cover 17-11
replace the lower backplane cover 15-31
verify seat 17-39
backplane connections
AEP connections
1-14
alarm wires 17-22
environmental alarm pins 17-24
LAN wires 17-26
modem 17-25
TBOS 17-25
timing wires 17-25
TL1 craft interface wires 17-27
verify 17-39
X.25 17-25
baluns see electrical interface adapter
battery termination
17-21
BER tester 1-4
BIC see EIA
BITS
BITS-1 Out
15-19
BITS-2 Out 15-19
BITS out references 17-76, 18-25
BITS timing pin fields 17-25
external timing pin assignments 17-25
facilities 17-76, 18-24
timing setup 4-9
blade see card
BLSR
DRI seeDRI
switches see external switching commands
add a node
14-2
change node ID 20-16
choose properties 5-12
create a BLSR on a node 19-23
create a four-fiber BLSR manually 20-48
create a four-fiber BLSR using the wizard 20-46
create a half circuit 6-52
create a two-fiber BLSR manually 20-18
create a two-fiber BLSR using the wizard 20-17
disable the ring 18-68
drop a node 14-6
exercise span 17-91
exercise the ring 19-10
four-fiber acceptance test 5-15
install fiber 17-52
modify ring ID, node ID, or ring reversion 13-18
remap K3 byte 17-87
remove a node 14-6
revertive switching 13-7, 13-14, 13-19, 20-17, 20-46
squelch table 21-5
subtend a BLSR 5-38
subtend a path protection 5-36
two-fiber acceptance test 5-13
upgrade from 2-fiber to 4-fiber 13-17
upgrade from a linear ADM 13-6, 13-8
upgrade from a path protection 13-13, 13-15
verify extension byte mapping 21-8
verify fiber connections 5-10
verify timing after dropping a node 18-67
BNC EIA
install
17-12
connect coaxial cable 17-32
insertion tool 1-4
see also high-density BNC EIA
BNC insertion tool
17-33
bottom brackets see air filter, external brackets
browser, required versions
3-2
C
cabinet compartment see front door
cable
connectors see EIAs
patch see patch cables
power see power cable
CAT-5 see LAN cable
RG179 see coaxial cable
RG59 see coaxial cable
To Next Page
Loading...
