Cisco ONS 15454 Series - Page 836

Index
IN-8
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
electrical circuits
DS-1, automatically routed
6-6
DS-1, manually routed 6-11
DS-1, multiple drops 6-14
DS-3, automatically routed 6-18
DS-3, manually routed 6-23
DS-3, multiple drops 6-25
provision a DS-1 circuit source and destination 17-96
provision a DS-3 circuit source and destination 22-3
electrical interface adapter
attach DS-1 cables
17-28
install 17-28
purpose 1-21
SMB EIA 17-15
environmental alarms
see also AIC card, external alarms and controls
see also AIC-I card, external alarms and controls
see also backplane connections
equipment
cards see card name
installation
1-2
user-supplied (tools) 1-3
ESD plug input 17-8
E-Series Ethernet cards
compatible GBICs
21-25
create a circuit in port-mapped mode 6-59
install 2-10
provision E-Series card mode 19-29
provision E-Series ports 19-13
provision ports for VLAN membership 19-14
refresh PM counts 20-33
route fiber 2-17
slot compatibility with XC10G cards 2-5
slot compatibility with XCVT cards 2-3
verify VLAN capacity 17-99
view Ethernet trunk utilization 20-5
view history PMs 19-41
view MAC address table 20-4
view maintenance information 15-17
view statistics 19-38
view utilization parameters 19-40
Ethernet
see also E-Series, ML-Series, and G-Series Ethernet
cards
circuits
6-56 to 6-85
create a manual cross-connect in port-mapped
mode
6-76
create RMON alarm thresholds 22-28
delete RMON alarm thresholds 22-26
E Series EtherSwitch circuit 6-56
E-Series multicard EtherSwitch manual
cross-connect
6-69
E-Series shared packed ring circuit 6-61
E-Series single-card EtherSwitch manual
cross-connect
6-66
G-Series circuit 6-73
hub-and-spoke circuit 6-64
MAC address table (E-Series only) 20-4
monitor Ethernet performance 8-5
polarity detection 17-27
provision ports for VLAN membership 19-14
refresh PM counts 19-42
test circuits 6-72
threshold variables (MIBs) 22-29
view history PMs 19-41
view utilization PM parameters 19-39
Ethernet cards
see CE-100T-8 card
see ML-Series, G-Series, and E-Series Ethernet cards
events
display using time zone
18-3
view history 22-8
exercise ring 19-10
extension byte 21-8
external alarms see AIC card or AIC-I card
external controls see AIC card or AIC-I card
external network element
19-32
external switching commands
BLSR ring switch test
17-87