Cisco ONS 15454 Series - Page 842

Index
IN-14
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
circuit source and destination options for VT
circuits
6-3
delete 18-65
fiber clips 2-17
four-port OC-12 card slots 12-13, 12-17
install fiber 2-14
install fiber boot 17-54
LED behavior during install 2-8
line terminating cards 18-7
monitor performance 8-6
path trace capability 19-47
protection 17-81
provision path trace 18-15
route fiber 2-17
slot compatibility with XC10G cards 2-5
slot compatibility with XCVT cards 2-3
verify installation 4-3
view PMs 22-1
office ground 17-18
office power
connect to shelf
17-19
turn on and verify 17-21
optical (STS) circuits
automatically routed
6-38
create an STS test circuit around the ring 6-93
manually routed 6-43
multiple drops 6-46
provision a circuit route 20-53
STS source and destination options 6-4
test 6-51
optical cards see OC-N cards
optical transmit and receive levels
2-15
optimized 1+1 optical protection
create
17-40
modify 17-41
description 4-11
orderwire
change settings on the AIC card
18-55
change settings on the AIC-I card 19-8
delete 20-23
provision 17-84
orderwire loop 17-85
OSPF
disable
18-18
set up or change 19-34
overhead circuits
create
6-85
delete 20-22
modify and delete 9-4
P
pass-through circuits see circuits
passwords
create new user
17-83, 17-84
login 17-68
patch cables
2-fiber BLSR test
5-14
4-fiber BLSR test 5-16
linear ADM test 5-9
point-to-point test 5-5
USPR test 5-23, 5-34
path protection
DRI see DRI
acceptance test
5-22
add a node 14-9
automatically route a circuit during an upgrade 20-95
create a half circuit 6-54
edit path protection circuit path selectors 19-22
install fiber 17-49
manually route a circuit during an upgrade 20-95
open-ended 5-31, 5-33
perform a span protection switching test 17-95
provision a half circuit source and destination 20-6
provision nodes 5-20
provision path selectors 19-12
remove a node 14-11
subtend a path protection 5-37