Cisco ONS 15454 Series - Page 847

Index
IN-19
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
see revertive switching
system see networks
T
tables
see also List of Tables
change format
A-11
display hidden columns A-11
print data 22-5
resize columns A-11
sort A-11
TCA 18-11
TCC2 card
clear the database for disaster recovery
15-8
craft wires vs. RS-232 port 17-27
database backup 15-4
install 17-42
LAN access 3-3, 3-5, 17-26
reboot behavior 19-32
reboot using LCD 17-72
reset 15-14, 20-49
restore the database 15-5
slot compatibility with XC10G cards 2-5
slot compatibility with XCVT cards 2-3
soft reset 15-14
switch test 20-40
TL1 access 17-27
upgrade to the TCC2P card 12-3
verify installation 4-2
TCC2P card
clear the database for disaster recovery
15-8
database backup 15-4
install 17-42
LAN access 3-3, 3-5, 17-26
reboot behavior 19-32
reboot using LCD 17-72
reset 20-49
restore the database 15-5
secure mode option 4-7
slot compatibility with XC10G cards 2-5
slot compatibility with XCVT cards 2-3
soft reset 15-14
switch test 20-40
TL1 access 17-27
upgrade from the TCC2 12-3
verify installation 4-2
TCP/IP
change configuration for Windows 2000
17-57, 17-60,
17-62
change configuration for Windows 98 17-56, 17-59
change configuration for Windows NT 17-57, 17-59, 17-62
change configuration for Windows XP 17-58, 17-60, 17-63
Telcordia 8-1
terminal lug 2-18, 2-19
terminal system see point-to-point
test circuits
create a G-Series Ethernet test circuit
6-81
create an electrical test circuit 6-36
create an E-Series Ethernet test circuit 6-72
create an optical test circuit 6-51
create an STS test circuit around the ring 6-93
T-handle hex tool 1-2
third-party equipment
create DCC tunnel
20-7
open-ended path protection 5-32
remap K3 byte for BLSR 17-87
threshold crossing alert 18-11
tie-down bar 22-27
tie wraps 1-2, 1-3
timed out see idle time
time zone
change
18-16
display events using time zone 18-3
select 4-6
timing
BITS see BITS
change node timing
10-5