Page 5-285
System Features
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
System Programming Using an Administrator's Station
FEATURES
5
3.) Press or ACCEPT to save the new message. The display shows DATA-
BASE UPDATED and then returns to the SELECT DND MESSAGE
prompt. (Or, to cancel your entry, press or
CANCEL. The display shows
NO UPDATE PERFORMED.)
4.) To program another message, scroll to the desired message and repeat these
steps.
5.) Press again to exit to the ENTER SYSTEM OPTION prompt.
b. Password: Allows you to set a password that limits access to the Administrator
programming feature. To select it, press or the
PASSWORD menu button.
Then do the following:
1.) The display shows CHANGE PASSWORD TO. Enter a password of up to
eight digits, then press . (Or, to erase the password and leave it blank, just
press #.)
2.) The display shows VERIFY PASSWORD. Enter the password exactly as
you did in the step above, followed by . The display returns to the
ENTER SYSTEM OPTION prompt. (If you hear reorder tones and see an
error message, the passwords did not match and you must start over at the
CHANGE PASSWORD prompt.)
c. Reminder Messages: Allows you to program the reminder messages used by the
stations. To select it, press or the
REMINDER MSGS menu button. Then do the
following:
1.) The display shows SELECT REMINDER MSG #. Enter a message number
or scroll to the desired message. (To scroll to the correct message press the
Volume button or the
SCROLL plus NEXT and PREVIOUS menu buttons.)
2.) When the display shows the desired message, enter the new message as
described in paragraph 52.26 on page 5-277.
3.) Press or ACCEPT to save the new message. The display shows DATA-
BASE UPDATED and then returns to the SELECT REMINDER MSG
prompt. (Or, to cancel your entry, press or CANCEL. The display shows
NO UPDATE PERFORMED.)
4.) To program another message, scroll to the desired message and repeat these
steps.
5.) Press again to exit to the ENTER SYSTEM OPTION prompt.
d. Station Extensions: Allows you to assign new extension numbers to stations. To
select it, press or the
STN EXTENSION menu button.
If programming a station:
1.) Press or CHANGE EXT. The display shows ENTER STATION EXTEN-
SION. Enter the extension number of the station to be programmed using
one of the following methods. (If you enter an invalid extension number, you
hear reorder tones and must try again.)
Enter a complete number: Enter the extension number using your keypad.
When a valid number is entered, the circuit information appears. Press
again to continue.
To Next Page
Loading...
