Send documentation comments to mdsfeedback-doc@cisco.com
48-31
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 48 Configuring FCIP
Using the FCIP Wizard
Caution FCIP write acceleration with FCIP ports as members of PortChannels in Cisco MDS SAN-OS Release
2.0(1b) and later NX-OS are incompatible with the FCIP write acceleration in earlier releases.
Configuring FCIP Write Acceleration
You can enable FCIP write acceleration when you create the FCIP link using the FCIP Wizard.
To enable write acceleration on an existing FCIP link, follow these steps:
Step 1 Choose ISLs > FCIP from the Physical Attributes pane on Fabric Manager.
You see the FCIP profiles and links in the Information pane.
On Device manager, choose IP > FCIP.
You see the FCIP dialog box.
Step 2 Click the Tunnels (Advanced) tab.
You see the FICP link information (see Figure 48-23).
Figure 48-23 FCIP Tunnels (Advanced) Tab
Step 3 Check or uncheck the Write Accelerator check box.
Step 4 Choose the appropriate compression ratio from the IP Compression drop-down list.
Step 5 Click the Apply Changes icon to save these changes.
Step 1 Choose ISLs > FCIP from the Physical Attributes pane on Fabric Manager.
You see the FCIP profiles and links in the Information pane.
On Device manager, choose IP > FCIP.
You see the FCIP dialog box.
Step 2 Click the Tunnels (Advanced) tab.
You see the FICP link information (see Figure 48-23).
To Next Page
Loading...
Need help?
General
