Send documentation comments to mdsfeedback-doc@cisco.com
50-26
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 50 Configuring iSCSI
Configuring iSCSI
Figure 50-24 Edit Local Zone Database Dialog Box in Fabric Manager
Step 2 Select the VSAN you want to add the iSCSI host initiator to and click OK.
You see the available zones and zone sets for that VSAN (see Figure 50-25).
Figure 50-25 Available Zones and Zone Sets
Step 3 From the list of available devices with iSCSI host initiators, drag the initiators to add into the zone.
Step 4 Click Distribute to distribute the change.
iSCSI-Based Access Control
iSCSI-based access control is applicable only if static iSCSI virtual targets are created (see the “Static
Mapping” section on page 50-10). For a static iSCSI target, you can configure a list of iSCSI initiators
that are allowed to access the targets.
By default, static iSCSI virtual targets are not accessible to any iSCSI host. You must explicitly configure
accessibility to allow an iSCSI virtual target to be accessed by all hosts. The initiator access list can
contain one or more initiators. The iSCSI initiator can be identified by one of the following mechanisms:
• iSCSI node name
• IPv4 address and subnet
To Next Page
Loading...
Need help?
General
