Send documentation comments to mdsfeedback-doc@cisco.com
14-22
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 14 Configuring FlexAttach Virtual pWWN
Using the Server Admin FlexAttach Wizards
The New Port window is displayed. (Figure 14-16)
Step 7 In the New Port selection window, select the port on which the spare server is connected.
Step 8 Click Next.
The Server WWN window is displayed. (Figure 14-21)
Figure 14-21 Server WWN Entries
Step 9 In the Server WWN window displayed, enter the existing FlexAttach server virtual port WWN to be
replaced, and the new server physical port WWN.
Step 10 Check the Allow wizard to change from “pWWN to vPWWN” mapping to “interface to vPWWN”
mapping check box to remove the pWWN to vPWWN entry from the CFS Region mapping table, and
configure the mapping only at the interface.
Step 11 Click Finish to complete the FlexAttach configuration for the spare server.
Replacing with a Server on a Different Switch
To replace a server with a spare server on a different switch, follow these steps:
Step 1 In the Fabric Manger window, select Tools > FlexAttach > Replace Server.
The Replace Server wizard is displayed. (Figure 14-18)
To Next Page
Loading...
Need help?
General
