Send documentation comments to mdsfeedback-doc@cisco.com
50-5
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 50 Configuring iSCSI
Configuring iSCSI
Figure 50-5 iSCSI Tables in Fabric Manager
The Control tab is the default tab. You see the iSCSI enable status for all switches in the fabric that
contain IPS ports.
Step 2 Choose enable from the Command column for each switch that you want to enable iSCSI on.
Step 3 Click the Apply Changes icon to save these changes.
Caution When you disable this feature, all related configurations are automatically discarded.
Creating iSCSI Interfaces
Each physical Gigabit Ethernet interface on an IPS module or MPS-14/2 module can be used to translate
and route iSCSI requests to Fibre Channel targets and responses in the opposite direction. To enable this
capability, the corresponding iSCSI interface must be in an enabled state.
Using the iSCSI Wizard
To use the iSCSI wizard in Fabric Manager, follow these steps:
Step 1 Click the iSCSI Setup Wizard icon.
You see the iSCSI Wizard Configure Initiator dialog box shown in Figure 50-6.
To Next Page
Loading...
Need help?
General
