Send documentation comments to mdsfeedback-doc@cisco.com
61-5
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 61 Configuring System Message Logging
System Message Logging Configuration
Figure 61-2 Switch Logging Tab in Fabric Manager
Step 4 Select a switch in the Information pane.
Step 5 Select a severity level from the Console Severity drop-down list in the row for that switch.
Step 6 Click the Apply Changes icon.
Module Logging
By default, logging is enabled at level 7 for all modules. You can enable or disable logging for each
module at a specified level.
To configure the severity level for a logging facility, follow these steps:
Step 1 In Fabric Manager, expand Switches, expand Events and select SysLog in the Physical Attributes pane.
In Device Manager, choose Logs > Syslog > Setup and click the Switch Logging tab in the Syslog
dialog box.
You see the switch information shown in Figure 61-3 or Figure 61-4.
Figure 61-3 Switch Logging Tab in Fabric Manager
To Next Page
Loading...
Need help?
General
