Send documentation comments to mdsfeedback-doc@cisco.com
14-10
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 14 Configuring FlexAttach Virtual pWWN
Using the Server Admin FlexAttach Wizards
Pre-Configuring FlexAttach for All the Ports
Using the Pre-Configure Server Basic configuration wizard, you can set the following port
configurations for all the ports in one or more switches in common:
–
Enable or disable FlexAttach Auto on all ports
–
Set the default VSAN ID for all the ports
–
Set the interface status for all the ports.
To pre-configure a common setting for all the ports in one or more switches, follow these steps:
Step 1 In the Fabric Manger window, select Tools > FlexAttach > Pre-configure Server.
The Pre-Configure Wizard is displayed. (Figure 14-9)
Figure 14-9 Pre-Configure Server Wizard
Step 2
In the Pre-Configure Server window, click the Basic radio button to configure a common setting to all
the ports on one or more switches.
The Basic Configuration window is displayed. (Figure 14-10)
To Next Page
Loading...
