Cisco AP775A - Nexus Converged Network Switch 5010 User Manual

Send documentation comments to mdsfeedback-doc@cisco.com
56-3
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 56 Configuring Fibre Channel Write Acceleration
Default Settings
Figure 56-2 FC Write Acceleration Dialog Box
Step 3 Select the initiator and target WWNs and VSAN IDs and check the WriteAcc check box to enable Fibre
Channel write acceleration on this SCSI flow.
Step 4 (Optional) Enable SCSI flow statistics on this SCSI flow at this time by checking the Enable Statistics
check box.
Step 5 (Optional) Set the BufCount value to the number of 2K buffers used by the SCSI target.
Step 6 Click Create to create this SCSI flow with Fibre Channel write acceleration.
Default Settings
Table 56-1 lists the default settings for Fibre Channel write acceleration parameters.
Ta b l e 56-1 Default Fibre Channel Write Acceleration Parameters
Parameters Default
Fibre Channel write acceleration Disabled.
Fibre Channel write acceleration buffers 1024.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English