Send documentation comments to mdsfeedback-doc@cisco.com
66-4
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 66 Troubleshooting Your Fabric
Analyzing Switch Fabric Configuration
Figure 66-1 Results of a Switch Health Analysis
Step 3 Click Clear to remove the contents of the Switch Health Analysis window.
Step 4 Click Close to close the window.
Analyzing Switch Fabric Configuration
The Fabric Configuration option lets you analyze the configuration of a switch by comparing the current
configuration to a specific switch or to a policy file. You can save a switch configuration to a file and
then compare all switches against the configuration in the file.
To use the Fabric Configuration option in Fabric Manager to analyze the configuration of a switch,
follow these steps:
Step 1 Choose Tools > Health > Fabric Configuration.
You see the Fabric Configuration Analysis dialog box.
Step 2 Decide whether you want to compare the selected switch to another switch, or to a policy file.
• If you are making a switch comparison, select Policy Switch and then click the drop-down arrow to
see a list of switches.
• If you are making a policy comparison, select Policy File. Then click the ... button to the right of
this option to browse your file system and select a policy file (*.XML).
Step 3 Click Rules to set the rules to apply when running the Fabric Configuration Analysis tool.
You see the Rules window.
Step 4 Change the rules as needed and click OK.
Step 5 Click Compare.
The system analyzes the configuration and displays issues that arise as a result of the comparison as
shown in
Figure 66-2.
To Next Page
Loading...
Need help?
General
