Send documentation comments to mdsfeedback-doc@cisco.com
14-18
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 14 Configuring FlexAttach Virtual pWWN
Using the Server Admin FlexAttach Wizards
Figure 14-17 Existing Server Virtual Port WWN Entry
Step 10 In the Server WWN window, enter the existing server virtual port WWN to be moved.
Step 11 Click Finish.
Replacing a Server with Another Server
You can use the Replace Server wizard to accomplish the following tasks:
• Replace a failed server with a new server onto the same port without changing the SAN. The new
server gets the same virtual pWWN as the failed server because the virtual pWWN is assigned to
the port.
• Replace a server with a spare server on the same NPV device or a different NPV device, which can
be brought online without changes to the SAN. This is achieved by moving the virtual port WWN
from the current server port to the spare port.
To Next Page
Loading...
Need help?
General
