Send documentation comments to mdsfeedback-doc@cisco.com
14-21
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 14 Configuring FlexAttach Virtual pWWN
Using the Server Admin FlexAttach Wizards
Figure 14-20 Server WWN Entries
Step 7
In the Server WWN window, enter the existing FlexAttach server virtual port WWN to be replaced, and
the new server physical port WWN.
Step 8 Click Finish to complete the FlexAttach configuration for the new server.
Replacing the Server to a Different Port on the Same Switch
To replace a server with a spare server on a different port in the same switch, follow these steps:
Step 1 In the Fabric Manger window, select Tools > FlexAttach > Replace Server.
The Replace Failed Server wizard is displayed. (Figure 14-18)
Step 2 In the Replace Failed Server wizard, click the With Spare Server on Same NPV Switch radio button.
Step 3 Click Next.
The Choose Failed Port window is displayed. (Figure 14-19)
Step 4 In the Choose Failed Port selection window, from the Select a Switch drop-down list, select the switch.
Step 5 From the list of interfaces displayed, select the port from which the server needs to be detached.
Step 6 Click Next.
To Next Page
Loading...
Need help?
General
