Cisco AP775A - Nexus Converged Network Switch 5010 User Manual

Send documentation comments to mdsfeedback-doc@cisco.com
62-15
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 62 Configuring Call Home
Periodic Inventory Notification
Configuring HTTPS Support
Any pre-defined or user-defined destination profiles can be configured to enable or disable a particular
transport method. The transport methods are HTTP and email.
To enable or disable transport method for a destination profile, follow these steps:
Periodic Inventory Notification
You can configure the switch to periodically send a message with an inventory of all the software
services currently enabled and running on the switch along with hardware inventory information. The
inventory is modified each time the switch is restarted nondisruptively.
By default, this feature is disabled in all switches in the Cisco MDS 9000 Family. When you enable this
feature without configuring an interval value, the Call Home message is sent every 7 days. This value
ranges from 1 to 30 days.
Enabling Periodic Inventory Notifications Using Fabric Manager
To enable periodic inventory notification in a Cisco MDS 9000 Family switch using Fabric Manager,
follow these steps:
Step 1 Select a switch in the Fabric pane.
Step 2 Expand Switches, expand Events, and select Call Home in the Physical Attributes pane.
You see the Call Home information in the Information pane.
Step 3 Click the Periodic Inventory tab.
You see the Call Home periodic inventory information shown in Figure 62-12.
Command Purpose
Step 1
switch# config t
Enters configuration mode.
Step 2
switch(config)# callhome
switch(config-callhome)#
Enters Call Home configuration submode.
Step 3
switch(config-callhome)#
destination-profile CiscoTAC-1
transport-method http
Optional. Enables predefined destination profile
CiscoTAC-1 for http transport-method.
Note For user-defined destination profiles, e-mail is
the default. You can enable either or both
transport mechanisms. If you disable both
methods, e-mail will be enabled.
Step 4
switch(config-callhome)# no
destination-profile CiscoTAC-1
transport-method email
Optional. Disables predefined destination profile
CiscoTAC-1 for email transport-method.
Step 5
switch(config-callhome)#
destination-profile full-txt
transport-method http
Optional. Enables predefined full-txt-destination profile
for HTTP transport method.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English