Send documentation comments to mdsfeedback-doc@cisco.com
30-27
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 30 Configuring and Managing Zones
Zone Set Distribution
Step 1 Expand a VSAN and select a zone set in the Logical Domains pane.
You see the zone set configuration in the Information pane. The Active Zones tab is the default.
Step 2 Click the Policies tab.
You see the configured policies for the zone (see Figure 30-27).
Figure 30-27 Configured Policies for the Zone
Step 3
In the Propagation column, choose fullZoneset from the drop-down menu.
Step 4 Click Apply Changes to propagate the full zone set.
Enabling a One-Time Distribution
You can perform a one-time distribution of inactive, unmodified zone sets throughout the fabric. To
propagate a one-time distribution of the full zone set using Fabric Manager, follow these steps:
Step 1 Choose Zone > Edit Local Full Zone Database.
You see the Edit Local Full Zone Database dialog box.
Step 2 Click the appropriate zone from the list in the left pane.
Step 3 Click Distribute to distribute the full zone set across the fabric.
This procedure only distributes the full zone set information; it does not save the information to the
startup configuration. You must explicitly save the running configuration to the startup configuration
issue the to save the full zone set information to the startup configuration.
Note The one-time distribution of the full zone set is supported in interop 2 and interop 3 modes, not in
interop 1 mode.
To Next Page
Loading...
Need help?
General
