Send documentation comments to mdsfeedback-doc@cisco.com
62-30
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 62 Configuring Call Home
Event Triggers
Event Triggers
This section discusses Call Home trigger events. Trigger events are divided into categories, with each
category assigned CLI commands to execute when the event occurs. The command output is included in
the transmitted message.
Table 62-2 lists the trigger events.
Ta b l e 62-2 Event Triggers
Event Alert Group Event Name Description
Call Home
Message Level
Call Home System and
CISCO_TAC
SW_CRASH A software process has crashed with a
stateless restart, indicating an
interruption of a service.
5
System and
CISCO_TAC
SW_SYSTEM_INCONSISTEN
T
Inconsistency detected in software or file
system.
5
Environmental
and
CISCO_TAC
TEMPERATURE_ALARM Thermal sensor indicates temperature
reached operating threshold.
6
POWER_SUPPLY_FAILURE Power supply failed. 6
FAN_FAILURE Cooling fan has failed. 5
Line Card
Hardware and
CISCO_TAC
LINECARD_FAILURE Line card hardware operation failed. 7
POWER_UP_DIAGNOSTICS_
FAILURE
Line card hardware failed power-up
diagnostics.
7
Line Card
Hardware and
CISCO_TAC
PORT_FAILURE Hardware failure of interface port(s). 6
Line Card
Hardware,
Supervisor
Hardware, and
CISCO_TAC
BOOTFLASH_FAILURE Failure of boot compact Flash card. 6
Supervisor
Hardware and
CISCO_TAC
NVRAM_FAILURE Hardware failure of NVRAM on
Supervisor hardware.
6
Supervisor
Hardware and
CISCO_TAC
FREEDISK_FAILURE Free disk space is below a threshold on
Supervisor hardware.
6
Supervisor
Hardware and
CISCO_TAC
SUP_FAILURE Supervisor hardware operation failed. 7
POWER_UP_DIAGNOSTICS_
FAILURE
Supervisor hardware failed power-up
diagnostics.
7
Supervisor
Hardware and
CISCO_TAC
INBAND_FAILURE Failure of in-band communications path. 7
Supervisor
Hardware and
CISCO_TAC
EOBC_FAILURE Ethernet out-of-band channel
communications failure.
6
To Next Page
Loading...
Need help?
General
