Send documentation comments to mdsfeedback-doc@cisco.com
11-5
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 11 On-Demand Port Activation Licensing
Configuring Port Activation Licenses
Figure 11-5 Licenses Dialog Box
Step 2
Click the Port Licensing tab.
You see the licenses that are in use as shown in Figure 11-6.
Figure 11-6 Licenses in Use
Step 3
Click Close to close the dialog box.
Making a Port Eligible for a License
By default, all ports are eligible to receive a license. However, if a port has already been made ineligible
and you prefer to activate it, then you must make that port eligible
Note The dialog box shown in Figure 11-7 applies only to the Cisco MDS 9124 Fabric Switch.
To make multiple ports eligible to acquire a license using Device Manager, follow these steps:
Step 1 Choose Interface > FC All and click the License tab or hold down the Control key, and then click each
port that you want to make eligible.
Step 2 Right-click the selected ports, select Configure, and click the License tab.
You see the FC Interfaces dialog box as shown in Figure 11-7.
To Next Page
Loading...
Need help?
General
