Send documentation comments to mdsfeedback-doc@cisco.com
41-20
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 41 Configuring RADIUS and TACACS+
Server Groups
This section includes the following topics:
• About Configuring Server Groups, page 41-20
• Configuring Server Groups, page 41-20
About Configuring Server Groups
You can configure these server groups at any time but they only take effect when you apply them to an
AAA service. You configure AAA policies for CLI users or Fabric Manager or Device Manager users.
Configuring Server Groups
To configure a RADIUS or TACACS+ server group using Fabric Manager, follow these steps:
Step 1 Expand Switches > Security, and then select AAA.
You see the AAA configuration in the Information pane shown in Figure 41-6. If you do not see the
screen in Figure 41-6, click the Server Groups tab.
You see the RADIUS or TACACS+ server groups configured.
Figure 41-6 AAA Server Groups
Step 2 Click Create Row to create a server group.
You see the Create Server dialog box.
Step 3 Select the radius radio button to add a RADIUS server group or select tacacs+ to add a TACACS+ server
group.
Step 4 Supply server names for the ServerIdList field.
Step 5 Set the DeadTime field for the number of minutes that a server can be nonresponsive before it is marked
as bypassed. See the
“About Bypassing a Nonresponsive Server” section on page 41-21.
Step 6 Click Create to create this server group.
Step 7 Click the Applications tab to assign this server group to an application (see Figure 41-7).
You can associate a server group with all applications or you can specify certain applications.
To Next Page
Loading...
Need help?
General
