Send documentation comments to mdsfeedback-doc@cisco.com
50-62
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 50 Configuring iSCSI
iSCSI Authentication Setup Guidelines and Scenarios
e. Click on the zoneset-iscsi folder and click Insert.
f. Set the Zone Name field to iscsi-zone-1 and click OK.
g. Set the Zone Name field to iscsi-zone-2 and click OK.
h. Click Activate to activate the new zone set.
i. Click Continue Activation to finish the activation.
Step 11 Bring up the iSCSI hosts (host 1 and host 2).
Step 12 Show all the iSCSI sessions.
a. In Device Manager, choose Interfaces > Monitor > Ethernet.
b. Click the iSCSI connections tab to show all the iSCSI sessions.
c. In Device Manager, choose IP > iSCSI and select the Session Initiators tab.
d. Click Details.
Step 13 In Fabric Manager, choose End Devices > iSCSI in the Physical Attributes pane to verify the details of
the two iSCSI initiators
Step 14 In Fabric Manager, choose Zones > Edit Local Full Zone Database to view the active zone set. The
iSCSI initiators' FC IDs are resolved.
Step 15 In Device Manager, Choose FC > Name Server. The Fibre Channel name server shows the virtual N
ports created for the iSCSI hosts.
Step 16 In Device Manager, Choose FC > Name Server.
Step 17 Click the Advanced tab. Verify the detailed output of the iSCSI initiator nodes in the Fibre Channel
name server.
Target Storage Device Requiring LUN Mapping
Sample scenario 2 assumes the following configuration (see Figure 50-43):
• Access control is based on Fibre Channel zoning.
• There is target-based LUN mapping or LUN masking.
• There is no iSCSI authentication (none).
• The iSCSI initiator is assigned to different VSANs.
To Next Page
Loading...
