Send documentation comments to mdsfeedback-doc@cisco.com
26-12
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 26 Configuring and Managing VSANs
Default Settings
Step 3 Click Apply Changes to save these changes, or click Undo Changes to discard any unsaved changes.
About Interop Mode
Interoperability enables the products of multiple vendors to come into contact with each other. Fibre
Channel standards guide vendors towards common external Fibre Channel interfaces. See the
“Switch
Interoperability” section on page 37-8.
About FICON VSANs
You can enable FICON in up to eight VSANs. See the “FICON VSAN Prerequisites” section on
page 36-7.
Default Settings
Table 26-2 lists the default settings for all configured VSANs.
Ta b l e 26-2 Default VSAN Parameters
Parameters Default
Default VSAN VSAN 1.
State Active state.
Name Concatenation of VSAN and a four-digit string representing the
VSAN ID. For example, VSAN 3 is VSAN0003.
Load-balancing attribute OX ID (src-dst-ox-id).
To Next Page
Loading...
Need help?
General
