Send documentation comments to mdsfeedback-doc@cisco.com
44-36
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 44 Configuring IPsec Network Security
Crypto IPv4-ACLs
About Crypto Map Set Application
You need to apply a crypto map set to each interface through which IPsec traffic will flow. Applying the
crypto map set to an interface instructs the switch to evaluate all the interface's traffic against the crypto
map set and to use the specified policy during connection or SA negotiation on behalf of the traffic to be
protected by crypto.
You can apply only one crypto map set to an interface. You can apply the same crypto map to multiple
interfaces. However, you cannot apply more than one crypto map set to each interface.
Applying a Crypto Map Set
To apply a crypto map set to an interface using Fabric Manager, follow these steps:
Step 1 Expand Switches > Security and then select IPSEC in the Physical Attributes pane.
You see the IPsec configuration in the Information pane (see Figure 44-32).
Figure 44-32 IPsec Configuration
To Next Page
Loading...
Need help?
General
