Send documentation comments to mdsfeedback-doc@cisco.com
54-13
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 54 Configuring IPv6 for Gigabit Ethernet Interfaces
Configuring IPv6 Static Routes
Step 1 Choose IP > Routing. You see the IP Routing Configuration dialog box. (see Figure 54-11).
Figure 54-12 IP Routing Configuration in Device Manager
Step 2 Check the Routing Enabled check box.
Step 3 Click Apply to save these changes or click Close to discard any unsaved changes.
Configuring IPv4 and IPv6 Protocol Addresses
When an interface in a Cisco networking device is configured with both an IPv4 and an IPv6 address,
the interface can send and receive data on both IPv4 and IPv6 networks.
To configure an interface in a Cisco networking device to support both the IPv4 and IPv6 protocol stacks
using Device Manager, follow these steps:
Step 1 Click Interfaces > Gigabit Ethernet and iSCSI.
You see the Gigabit Ethernet Configuration dialog box.
Step 2 Click the IP Address field that you want to configure and click Edit IP Address.
You see the IP Address dialog box.
Step 3 Click Create and set the IP Address/Mask field, using the IPv4 or IPv6 format.
Step 4 Click Create to save these changes or click Close to discard any unsaved changes.
Configuring IPv6 Static Routes
Cisco MDS NX-OS supports static routes for IPv6. This section includes the following topics:
• Configuring a IPv6 Static Route, page 54-13
Configuring a IPv6 Static Route
You must manually configure IPv6 static routes and define an explicit path between two networking
devices. IPv6 static routes are not automatically updated and must be manually reconfigured if the
network topology changes.
To Next Page
Loading...
Need help?
General
