Send documentation comments to mdsfeedback-doc@cisco.com
66-10
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 66 Troubleshooting Your Fabric
Running CLI Commands
The default is 30 seconds.
Step 4 Select the folder where you want the text files (containing the tech support information) to be written.
Step 5 Check the Save Map check box if you want to save a screenshot of your map as a JPG file.
Step 6 Check the Compress all files as check box to compress the files into a zip file.
Step 7 Click OK to start issuing the show tech support command to the switches you specified, or click Close
to close the Show Tech Support dialog box without issuing the show tech support command (see
Figure 66-7).
In the Status column next to each switch, you see a highlighted status. A yellow highlight indicates that
the show tech support command is currently running on that switch. A red highlight indicates an error.
A green highlight like the one shown in
Figure 66-7 indicates that the show tech support command has
completed successfully.
Figure 66-7 Successful Results of the Show Tech Support Command
Step 8 If prompted, enter your user name and password in the appropriate fields for the switch in question.
Note In order for Fabric Manager to successfully issue the show tech support command on a switch,
that switch must have this user name and password. Fabric Manager is unable to log into a switch
that does not have a user name and password and an error is returned for that switch.
Note If you would like to view output files of the show tech support command without using Fabric
Manager, open them with any text editor. Each file is named with the switch’s IP address and has
a .TXT extension (for example, 111.22.33.444.txt).
Running CLI Commands
As of Cisco MDS NX-OS Release 4.1(1), you can use the Run CLI Commands feature to run a CLI
command on multiple switches.
To run CLI commands using Fabric Manager, follow these steps:
To Next Page
Loading...
Need help?
General
