Send documentation comments to mdsfeedback-doc@cisco.com
66-11
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 66 Troubleshooting Your Fabric
Running CLI Commands
Step 1 Choose Tools > Run CLI Commands.
You see the Run CLI Commands dialog box with all switches selected as shown in Figure 66-8.
Figure 66-8 Run CLI Commands Dialog Box
Step 2 Deselect the check box for the switch(es) for which you do not want to run CLI commands.
Step 3 Specify where you want the file to be saved.
Note A separate report is issued for each switch. Check the reports to verify whether a CLI command
failed.
Step 4 Enter the command(s) in the Command(s) text box. If the commands are configuration mode commands,
you must also enter the exit command.
Note For the commands to execute, you cannot be in configuration mode.
Step 5 Click OK to run the CLI command(s).
You see the Run CLI Commands dialog box showing the status of each switch as shown in Figure 66-9.
To Next Page
Loading...
Need help?
General
