Send documentation comments to mdsfeedback-doc@cisco.com
30-35
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 30 Configuring and Managing Zones
Zone Set Duplication
An edit box appears around the zone or zone set name.
Step 5 Enter a new name.
Step 6 Click Activate or Distribute.
Cloning Zones, Zone Sets, FC Aliases, and Zone Attribute Groups
To clone a zone, zone set, fcalias, or zone attribute group, follow these steps:
Step 1 Choose Zone > Edit Local Full Zone Database.
You see the Select VSAN dialog box.
Step 2 Select a VSAN and click OK.
You see the Edit Local Full Zone Database dialog box for the selected VSAN.
Step 3 Choose Edit > Clone.
You see the Clone Zoneset dialog box shown in Figure 30-36. The default name is the word Clone
followed by the original name.
Figure 30-36 Clone Zoneset Dialog Box
Step 4 Change the name for the cloned entry.
Step 5 Click OK to save the new clone.
The cloned database now appears along with the original database.
Migrating a Non-MDS Database
To use the Zone Migration Wizard to migrate a non-MDS database using Fabric Manager, follow these
steps:
Step 1 Choose Zone > Migrate Non-MDS Database.
You see the Zone Migration Wizard.
Step 2 Follow the prompts in the wizard to migrate the database.
To Next Page
Loading...
Need help?
General
