Send documentation comments to mdsfeedback-doc@cisco.com
36-16
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 36 Configuring FICON
Configuring FICON
Tip Using Device Manager, FICON auto-save can be invoked by multiple users logged on to the same
FICON-enabled switch. Device Manager performs a periodic auto-save on any FICON-enabled switch
causing increments in the FICON key counter. These increments highlight a change that has actually not
occurred. To avoid this we recommend that only one instance of Device Manager monitor a
FICON-enabled switch.
Setting Up a Basic FICON Configuration
This section steps you through the procedure to set up FICON on a specified VSAN in a Cisco MDS
9000 Family switch.
To create a FICON-enabled VSAN using Fabric Manager, follow these steps:
Step 1 Click the Create VSAN icon (see Figure 36-7).
Figure 36-7 Create VSAN Icon
You see the Create VSAN dialog box (see Figure 36-8).
To Next Page
Loading...
Need help?
General
