Send documentation comments to mdsfeedback-doc@cisco.com
50-37
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 50 Configuring iSCSI
Configuring iSLB
About iSLB Initiators
iSLB initiators provide the following features in addition to those supported by iSCSI initiators:
• An iSLB initiator also supports iSLB virtual targets. These targets are very similar to iSCSI virtual
targets with the exception that they do not include the advertise interface option and as a result are
distributable using CFS.
• Initiator targets–—These targets are configured for a particular initiator.
• Load balancing using iSCSI login redirect and VRRP—If load balancing is enabled, the IPS
Manager redirects incoming sessions to the best interface based on the calculated load for each
interface.
• Configuration distribution to other switches using CFS.
Configuring iSLB Using Device Manager
To configure iSLB using Device Manager, follow these steps:
Step 1 Choose IP > iSCSI iSLB.
You see the iSCSI iSLB dialog box shown in Figure 50-30.
Figure 50-30 iSCSI iSLB Dialog Box
Step 2 Click Create to create a new iSCSI iSLB initiator.
You see the Create iSCSI iSLB Initiators dialog box shown in Figure 50-31.
To Next Page
Loading...
Need help?
General
