Send documentation comments to mdsfeedback-doc@cisco.com
50-38
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 50 Configuring iSCSI
Configuring iSLB
Figure 50-31 Create iSCSI iSLB Initiators Dialog Box
Step 3 Set the Name or IP Address field to the iSLB name or IP address.
Step 4 Set the VSAN Membership field to the VSAN that you want the iSLB initiator in.
Also see the “Assigning VSAN Membership for iSLB Initiators” section on page 50-40.
Step 5 Check the Persistent check box to convert a dynamic nWWN to static for the iSLB initiator.
Also see the “Making the Dynamic iSLB Initiator WWN Mapping Static” section on page 50-40.
Step 6 (Optional) Check the SystemAssigned check box to have the switch assign the nWWN.
Step 7 (Optional) Set the Static WWN field to manually assign the static nWWN. You must ensure uniqueness
for this nWWN.
Step 8 (Optional) Check the Port WWN Mapping Persistent check box to convert dynamic pWWNs to static
for the iSLB initiator.
See the “Making the Dynamic iSLB Initiator WWN Mapping Static” section on page 50-40.
Step 9 (Optional) Check the SystemAssigned check box and set the number of pWWNs you want to have the
switch assign the PWWN.
Step 10 (Optional) Set the Static WWN(s) field to manually assign the static pWWNs.
You must ensure uniqueness for these pWWN.
To Next Page
Loading...
Need help?
General
