Send documentation comments to mdsfeedback-doc@cisco.com
13-14
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 13 Using the CFS Infrastructure
CFS Distribution over IP
Step 4 Select the peers, and then click Ok to add the peers to the list.
The peers are added to the list with To Be Added status.
Figure 13-8 Confirm Peer Selection
Step 5 Click Set to confirm adding the peers to the list and start the peers list propogation by CFS.
Removing an NPV Device from the Peer List
To delete a peer from the IP peer list using the Fabric Manager, follow these steps:
Step 1 From the Fabric Manager menu, select Tools > Other > NPV CFS Setup.
The NPV CFS Setup wizard is launched.
Step 2 From the NPV Device to retrieve peer list from drop-down list box, select the device to retrieve the
peer list from which you want to delete a peer.
Step 3 Do one of the following tasks to mark the peer or local host as deleted:
• To delete a peer from the peer list, select the peer from the list, and then click Delete.
• To delete the local host from the peer list, select the local NPV device and click Delete, or select all
the peers in the list, and then click Delete All.
Step 4 Click Ye s to delete the peer from the list.
Step 5 Click Set in the NPV CFS wizard. The following message box is displayed:
To Next Page
Loading...
Need help?
General
