Send documentation comments to mdsfeedback-doc@cisco.com
50-47
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 50 Configuring iSCSI
Configuring iSLB
Non-iSLB virtual targets will continue to support advertised interfaces option.
Tip The pending changes are only available in the volatile directory and are discarded if the switch is
restarted.
Distributing the iSLB Configuration Using CFS
This section contains the following:
• Enabling iSLB Configuration Distribution, page 50-47
• Locking the Fabric, page 50-48
• Committing Changes to the Fabric, page 50-48
• Discarding Pending Changes, page 50-48
• Clearing a Fabric Lock, page 50-49
• CFS Merge Process, page 50-49
• iSLB CFS Merge Status Conflicts, page 50-49
Enabling iSLB Configuration Distribution
To enable CFS distribution of the iSLB configuration using Device Manager, follow these steps:
Step 1 Choose Admin > CFS.
You see the CFS dialog box shown in Figure 50-35.
Figure 50-35 Enabling CFS in Device Manager
Step 2 Set the Command field to enable for the iSLB feature.
To Next Page
Loading...
Need help?
General
