Send documentation comments to mdsfeedback-doc@cisco.com
46-8
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 46 Configuring Port Security
Enabling Port Security
Step 9 Click Close to exit the Insert Port Security window.
Note To delete an entry in the Edit and Activate Configuration page of the wizard, select the entry and
click the Delete button.
Step 10 Click Finish to complete the Port Security Configuration for the selected switch.
Enabling Port Security
By default, the port security feature is disabled in all switches in the Cisco MDS 9000 Family.
To enable port security using Fabric Manager, follow these steps:
Step 1 Expand a VSAN and then select Port Security in the Logical Domains pane.
You see the port security configuration for that VSAN in the Information pane (see Figure 46-5).
Figure 46-5 Port Security Configuration
Step 2
Click the CFS tab.
You see the information show in Figure 46-6.
Figure 46-6 Port Security CFS
Step 3
Enable CFS on all participating switches in the VSAN by clicking each entry in the Global column and
selecting enable.
Step 4 Click Apply Changes to enable CFS distribution for the port security feature.
To Next Page
Loading...
Need help?
General
