Cisco AP775A - Nexus Converged Network Switch 5010 User Manual

Send documentation comments to mdsfeedback-doc@cisco.com
28-11
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 28 Creating Dynamic VSANs
DPVM Database Distribution
These changes are distributed to all switches in a fabric when you commit the changes. You can also
discard (abort) the changes at this point.
Tip See the “Viewing the Pending Database” section on page 28-8 to view the contents of the of the pending
database.
Disabling DPVM Database Distribution
These changes are distributed to all switches in a fabric when you commit the changes. You can also
discard (abort) the changes at this point.
Tip See the “Viewing the Pending Database” section on page 28-8 to view the contents of the pending
database.
To disable DPVM database distribution to the neighboring switches using Fabric Manager, follow these
steps:
Step 1 Expand Fabricxx> All VSANs and then select DPVM from the Logical Attributes pane.
You see the DPVM configuration in the Information pane.
Step 2 Click the CFS tab and select disable from the Admin drop-down menu.
Step 3 Click Apply Changes to save this change or click Undo Changes to discard the change.
About Locking the Fabric
The first action that modifies the existing configuration creates the DPVM pending database and locks
the feature in the fabric. Once you lock the fabric, the following conditions apply:
• No other user can make any configuration changes to this feature.
• A copy of the configuration database becomes the DPVM pending database. Modifications from this
point on are made to the DPVM pending database. The DPVM pending database remains in effect
until you commit the modifications to the DPVM pending database or discard (abort) the changes
to the DPVM pending database.
Locking the Fabric
To lock the fabric and apply changes to the DPVM pending database using Fabric Manager, follow these
steps:
Step 1 Expand Fabricxx> All VSANs and then select DPVM from the Logical Attributes pane.
You see the DPVM configuration in the Information pane.
Step 2 Click the Config Database tab and Create Row.
You see the Create Config Database dialog box shown in Figure 28-13.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English