Send documentation comments to mdsfeedback-doc@cisco.com
44-18
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 44 Configuring IPsec Network Security
Optional IKE Parameter Configuration
Figure 44-11 IKE Configuration
Step 2 Select the Global tab.
You see the global statistics of a specific IKE protocol in the Information pane (see Figure 44-12).
Figure 44-12 IKE Global Tab Information
Step 3 Enter a value (in seconds) in the KeepAliveInterval (sec). the The keepalive interval in seconds is used
by the IKE entity on the managed device with all the peers for the DOI corresponding to this conceptual
row.
Step 4 Click Apply Changes to save your changes.
Configuring the Initiator Version
To configure the initiator version using Fabric Manager, follow these steps:
Step 1 Expand Switches > Security and then select IKE.
To Next Page
Loading...
