Send documentation comments to mdsfeedback-doc@cisco.com
7-50
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 7 Fabric Manager Web Client
Admin
Step 5 From the Fabric drop-down list, choose the fabric for notification.
Step 6 Either check the VSAN Scope check box to receive notifications for all VSANs, or enter the VSAN IDs
in the ID List field to limit the VSANs for which you want to receive notifications.
Step 7 Enter the e-mail address for notifications in the Address field.
Step 8 From the Minimum Severity drop-down list, select the severity level of the messages to receive.
Step 9 Click Add to add the notification.
Note The traps sent by Fabric Manager Server correspond to the severity type followed by a text description:
trap type(s) = 40990 (emergency) 40991 (alert) 40992 (critical) 40993 (error) 40994
(warning) 40995 (notice) 40996 (info) 40997 (debug)textDescriptionOid = 1, 3, 6, 1, 4, 1,
9, 9, 40999, 1, 1, 3, 0
To remove a notification forward using Fabric Manager Web Client, follow these steps:
Step 1 Click the Admin tab, and then click Configure.
Step 2 Click Forwarding in the left navigation pane.
Step 3 Check the check box in front of the notification that you want to remove.
Step 4 Click Remove.
Viewing and Disconnecting Clients
To view or disconnect clients from the Fabric Manager Server using Fabric Manager Web Client, follow
these steps:
Step 1 Click the Admin tab, and then click Configure.
Step 2 Click Clients in the left navigation pane.
You see the Clients page shown in Figure 7-44.
To Next Page
Loading...
Need help?
General
