Send documentation comments to mdsfeedback-doc@cisco.com
7-57
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 7 Fabric Manager Web Client
Admin
Figure 7-52 Create Collection Dialog Box
Step 4 Select a fabric for which to collect performance data from the Fabric drop-down list.
Step 5 Either check the VSAN Scope check box to receive notifications for all VSANs, or enter the VSAN IDs
in the ID List field to limit the VSANs for which you want to collect performance data.
Step 6 Check the check boxes for the type(s) of entities for which you want to collect performance data.
Step 7 Check the check boxes for the type(s) of thresholds you want to enable.
Step 8 Click Create to add the collection and add it to the table.
Step 9 Repeat Steps 3 through 8 to continue adding roles.
Note Performance Manager shows statistics for fabrics that you have configured collections for using the
Collection Wizard.
To remove a collection using Fabric Manager Web Client, follow these steps:
Step 1 Click the Admin tab, and then click Configure.
Step 2 Click Collections in the left navigation pane.
Step 3 Check the check box next to the collection you want to remove and click Remove.
Configuring Other Statistics
To configue other statistics using Fabric Manager Web Client, follow these steps:
Step 1 Click the Admin tab, and then click Configure.
Step 2 Click Others in the left navigation pane.
You see the Others page as shown in Figure 7-53.
To Next Page
Loading...
Need help?
General
