Send documentation comments to mdsfeedback-doc@cisco.com
14-12
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 14 Configuring FlexAttach Virtual pWWN
Using the Server Admin FlexAttach Wizards
Figure 14-11 Pre-Configure Server - Finish
Pre-Configuring FlexAttach for Each Port Individually
Using the Pre-Configure Server Advanced configuration wizard, you can set the following port
configurations for each port in one or more switches individually:
–
Enable FlexAttach Auto on all ports.
–
Enable FlexAttach Auto or Manual on individual ports.
–
Set the virtual PWWN for ports where FlexAttach enabled Manually.
–
Set pWWN to vPWWN mapping.
–
Set the default VSAN ID for each port.
–
Set the Interface status for each port.
To pre-configure FlexAttach on each port individually, follow these steps:
Step 1 In the Fabric Manger window, select Tools > FlexAttach > Pre-configure Server.
The Pre-Configure Server window is displayed. (Figure 14-9)
Step 2 In the Pre-Configure Server window, click the Advanced radio button to configure FlexAttach on each
port individually.
The Pre-Configure Server Advanced configuration window is displayed. (Figure 14-12)
To Next Page
Loading...
Need help?
General
