Send documentation comments to mdsfeedback-doc@cisco.com
28-9
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 28 Creating Dynamic VSANs
DPVM
–
Learning new device logins— Occurs as and when new devices log in to the switch.
Enabling Autolearning
To enable autolearning using Fabric Manager, follow these steps:
Step 1 Expand Fabricxx> All VSANs and then select DPVM from the Logical Attributes pane.
You see the DPVM configuration in the Information pane.
Step 2 Click the Actions tab and check the Auto Learn Enable check box to enable autolearning (see
Figure 28-11).
Figure 28-11 DPVM Actions Tab
Step 3
Click the CFS tab and select commit to distribute these changes or abort to discard the changes.
Clearing Learned Entries
You can clear DPVM entries from the active DPVM database (if autolearn is still enabled) using one of
two methods.
To clear a single autolearn entry using Fabric Manager, follow these steps:
Step 1 Expand Fabricxx> All VSANs and then select DPVM from the Logical Attributes pane.
You see the DPVM configuration in the Information pane.
Step 2 Click the Actions tab and select clearOnWWN from the Auto Learn Clear drop-down men.
Step 3 Check the clear WWN check box next to the WWN of the autolearned entry that you want to clear.
Step 4 Click CFS and select commit to distribute these changes or abort to discard the changes.
To clear all autolearn entries using Fabric Manager, follow these steps:
Step 1 Expand Fabricxx> All VSANs and then select DPVM from the Logical Attributes pane.
You see the DPVM configuration in the Information pane.
Step 2 Click the Actions tab.
You see the DPVM Actions menu shown in Figure 28-12.
To Next Page
Loading...
Need help?
General
