Cisco AP775A - Nexus Converged Network Switch 5010 User Manual

Send documentation comments to mdsfeedback-doc@cisco.com
52-7
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 52 Configuring IP Storage
Configuring Gigabit Ethernet Interfaces for IPv4
Note The configuration requirements in Table 52-1 also apply to Ethernet PortChannels.
Verifying Gigabit Ethernet Connectivity
Once the Gigabit Ethernet interfaces are connected with valid IP addresses, verify the interface
connectivity on each switch. Ping the IP host using the IP address of the host to verify that the static IP
route is configured correctly.
Note If the connection fails, verify the following, and ping the IP host again:
- The IP address for the destination (IP host) is correctly configured.
- The host is active (powered on).
- The IP route is configured correctly.
- The IP host has a route to get to the Gigabit Ethernet interface subnet.
- The Gigabit Ethernet interface is in the up state.
Gigabit Ethernet IPv4-ACL Guidelines
Tip If IPv4-ACLs are already configured in a Gigabit Ethernet interface, you cannot add this interface to an
Ethernet PortChannel group.
Follow these guidelines when configuring IPv4-ACLs for Gigabit Ethernet interfaces:
• Only use Transmission Control Protocol (TCP) or Internet Control Message Protocol (ICMP).
Note Other protocols such as User Datagram Protocol (UDP) and HTTP are not supported in
Gigabit Ethernet interfaces. Applying an ACL that contains rules for these protocols to a
Gigabit Ethernet interface is allowed but those rules have no effect.
• Apply IPv4-ACLs to the interface before you enable an interface. This ensures that the filters are in
place before traffic starts flowing.
• Be aware of the following conditions:
– If you use the log-deny option, a maximum of 50 messages are logged per second.
Gigabit Ethernet 1/1 Gigabit Ethernet 1/1.100 No A subinterface cannot be configured on the same
subnet as the major interface.
mgmt0 Gigabit Ethernet 1/1.100 No The mgmt0 interface cannot be configured in the
same subnet as the Gigabit Ethernet interfaces or
subinterfaces.
mgmt0 Gigabit Ethernet 1/1 No
Table 52-1 Subnet Requirements for Interfaces (continued)
Interface 1 Interface 2
Same Subnet
Allowed Notes

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English