Send documentation comments to mdsfeedback-doc@cisco.com
66-12
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 66 Troubleshooting Your Fabric
Locating Other Switches
Figure 66-9 Run CLI Commands Status
Step 6 Click Close to close the dialog box.
Adjusting for Daylight Savings Time
Note Starting in 2007, daylight savings time in the United States starts on the second Sunday in March and
ends on the first Sunday in November.
You can use the Run CLI Commands feature in Fabric Manager to adjust the time change configuration
in your switches. Enter the following commands in the Command(s) text box.
config t
no clock summer-time
clock summer-time daylight_timezone_name 2 Sunday March 02:00 1 Sunday November 02:00 60
exit
Locating Other Switches
The Locate Switches option uses SNMPv2 and discovers devices responding to SNMP requests with the
read-only community string public. You can use this feature if:
• You have third-party switches that do not implement the FC-GS3 FCS standard that provides
management IP addresses.
• You want to locate other Cisco MDS 9000 switches in the subnet but are not physically connected
to the fabric (and therefore cannot be found via neighbors).
To Next Page
Loading...
Need help?
General
