Send documentation comments to mdsfeedback-doc@cisco.com
29-34
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 29 Configuring Inter-VSAN Routing
Default Settings
• If the failure is due to exceeding the maximum configuration limits in a fabric where the switches
are running more than one Cisco SAN-OS release, then either upgrade the switches running the
earlier release or reduce the number of IVR zones and IIVR zone members on the switches running
the more recent release to the earlier release limit (see the“IVR Limits Summary” section on
page 29-4).
• If the failure is due to exceeding maximum limits in a fabric where all switches are running the same
Cisco SAN-OS release, identify the switch that has the correct configuration and perform a CFS
commit to distribute the IVR configuration (see the “Configuring Default AFIDs” section on
page 29-12 and the“IVR Limits Summary” section on page 29-4).
• For other failures, resolve the error causing the merge failure on the switch that has the correct
configuration and perform a CFS commit to distribute the IVR configuration (see the “Configuring
Individual AFIDs” section on page 29-12).
After a successful CFS commit, the merge will be successful.
Default Settings
Table 29-6 lists the default settings for IVR parameters.
Table 29-6 Default IVR Parameters
Parameters Default
IVR feature Disabled.
IVR VSANs Not added to virtual domains.
IVR NAT Disabled.
QoS for IVR zones Low.
Configuration distribution Disabled.
To Next Page
Loading...
Need help?
General
