Send documentation comments to mdsfeedback-doc@cisco.com
44-20
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 44 Configuring IPsec Network Security
Optional IKE Parameter Configuration
Step 6 Click Create to create this initiator version or click Close to discard any unsaved changes.
Clearing IKE Tunnels or Domains
If an IKE tunnel ID is not specified for the IKE configuration, you can clear all existing IKE domain
connections.
To clear all the IKE Tunnels or Domains using Fabric Manager, follow these steps:
Step 1 Expand Switches > Security and then select IKE in the Physical Attributes pane.
You see the IKE configuration in the Information pane (see Figure 44-15).
Figure 44-15 IKE Configuration
Step 2 Click the Tunnels tab in the Information pane.
You see the IKE tunnels.
Step 3 Click the Action column and select Clear to clear the tunnel.
Refreshing SAs
To refresh the SAs after changing the IKEv2 configuration using Fabric Manager, follow these steps:
Step 1 Expand Switches > Security and then select IKE in the Physical Attributes pane.
You see the IKE configuration shown in Figure 44-16.
To Next Page
Loading...
