Send documentation comments to mdsfeedback-doc@cisco.com
54-15
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 54 Configuring IPv6 for Gigabit Ethernet Interfaces
Transitioning from IPv4 to IPv6
Transitioning from IPv4 to IPv6
Cisco MDS NX-OS does not support any transitioning mechanisms from IPv4 to IPv6. However, you
can use the transitioning schemes in the Cisco router products for this purpose. For information on
configuring Cisco routers to transition your network, refer to the
Implementing Tunneling for IPv6
chapter in the Cisco IOS IPv6 Configuration Guide.
Default Settings
Table 54-2 lists the default settings for IPv6 parameters.
Ta b l e 54-2 Default IPv6 Parameters
Parameters Default
IPv6 processing Disabled.
Duplicate address detection
attempts
0 (neighbor discovery disabled).
Reachability time 1000 milliseconds.
Retransmission time 30000 milliseconds.
IPv6-ACLs None.
To Next Page
Loading...
Need help?
General
