Send documentation comments to mdsfeedback-doc@cisco.com
A-1
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
APPENDIX
A
Launching Fabric Manager in Cisco SAN-OS
Releases Prior to 3.2(1)
This appendix provides instructions for launching Fabric Manager Client in Cisco SAN-OS releases
prior to 3.2(1).
This Appendix contains the following sections:
• Setting the Seed Switch in Cisco SAN-OS Releases 3.1(1) to 3.2(1), page A-1
• Setting the Seed Switch in Releases Prior to Cisco SAN-OS Release 3.1(1), page A-3
Setting the Seed Switch in Cisco SAN-OS Releases 3.1(1) to
3.2(1)
Note As of Cisco SAN-OS Release 3.1(1), the Fabric Manager login procedure changed. If you are running a
version of Cisco SAN-OS that is earlier than Cisco SAN-OS 3.1(1), follow the login instructions in the
“Setting the Seed Switch in Releases Prior to Cisco SAN-OS Release 3.1(1)” section on page A-3.
From Cisco SAN-OS Release 3.1(1) to Release 3.2(1), you must log in to Fabric Manager Server before
you discover or open fabrics, and these fabrics can have different user credentials. You can specify
different SNMP communities per switch on the Web Server.
Note The default user name is admin and the default password is password for your initial login. This
information is stored in the database. Both the Fabric Manager Server and the Web Server share the same
user credential database.
To log in to Fabric Manager Server and to open a fabric, follow these steps:
Step 1 Double-click the Fabric Manager Client icon on your workstation.
You see the Fabric Manager Server Login dialog box shown in Figure A-1.
To Next Page
Loading...
Need help?
General
