Send documentation comments to mdsfeedback-doc@cisco.com
13-12
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 13 Using the CFS Infrastructure
CFS Distribution over IP
Note If a new NPV switch is added to the fabric, you must launch the NPV CFS Setup wizard to update the
list, because Fabric Manager does not update the list automatically.
Adding Peers to List
To configure the static IP peers list using Fabric Manager, follow these steps:
Step 1 From the Fabric Manager menu, select Tools > Other > NPV CFS Setup .
Figure 13-5 NPV CFS Setup Menu
The NPV Device Selection dialog box is displayed with the list of NPV device peers retrieved from the
switch including the device name, device IP address, and the status of the peer.
To Next Page
Loading...
Need help?
General
